Here's the layout file if you want to play with it. Poor planning, needs more work, but since the build runs I just jammed in a box up-side-down instead. The original plan was to board-mount the level and gain pots with the tube facing down and the DC jack above it, but I tried and it didn't fit. The top-side has 3 jumpers, plus one on the daughter board. That is to say, a double-sided board isn't necessary, it's just for mechanical strength. I made a double-sided board so I could effectively solder wires and the daughter-board underneath, but of course there are no vias, so they still needed to be soldered to the underside. I wanted to see if I could squeeze it in to a 125B, so I made a layout using ExpressPCB Plus and etched the board. Well, if you don't mind a 1590BB there's this. "Understanding How Transistors Work" - Stompbox Studies "Everything You Need to Build a DIY Guitar Pedal" - Pedal Haven "So you’re starting out - A guide to what you’ll need to build pedals." This is an open community for the do-it-yourself pedal builders of reddit! Please use this subreddit to share knowledge, give/receive help, and show off your custom builds! Looking for troubleshooting help? Please read this first!
0 Comments
Leave a Reply. |